T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
a. Wind vinyl tape on the serrated part of the vane pump shaft.
b. Using the SST 09608-04031 or equivalent, press in the shaft with the bearing.
NOTICE: Be careful not to damage the oil seal. Using snap ring pliers, install a new snap ring to the front housing.
3. Install straight pins.
Using a plastic hammer, tap in two new pins to the front housing.
NOTICE: Be careful not to damage the pins.
4. Install cam ring.
Install the ring with the inscribed mark facing outward.
5. Install vane pump rotor.
a. Install the rotor with the inscribed mark facing outward.
b. Install a new snap ring to the vane pump shaft.
6. Install vane plates and gasket.
a. Install the ten plates with the round end facing outward.
b. Install a new gasket on the front housing.
NOTICE: Be careful the direction of the gasket.
7. Install side plate.
Align the holes of the side plate and straight pins, and install the side plate.