T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
8. Remove the nut, then the lower suspension arm.
Torque: 206 Nm (152 ft. lbs.).
HINT: At the time of installation, after stabilizing the suspension, torque the nut.
REPLACEMENT
1. Remove the bushing.
a. Cut off the bushing rubber, as shown in the illustration.
b. Using Special Service Tool (SST) 09726-35010 or equivalent, remove the bushing.
2. Install the bushing.
a. Apply soapy water on the front rubber part of a new bushing and fit SST 09726-35010 or equivalent on the bushing.
b. Using SST 09726-35010 or equivalent, install the bushing.
INSTALLATION
Installation is in the reverse order of removal. After installation, check the front wheel alignment.