T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
HINT:
-
Use this measurement for reference when adjusting the vehicle height.
-
After stabilizing the suspension, adjust the vehicle height by turning the adjust nut.
3. Loosen adjusting nut and remove anchor arm.
HINT: At the time of installation, tighten the adjusting nut to the bolt protrusion length is of before removal.
4. Remove torsion bar spring.
HINT: At the time of installation, please refer to the following items.
-
There are left and right matchmarks on the rear end of the torsion bar springs. Be careful not to interchange them.
-
Apply a light coat of Multipurpose (MP) grease to the spline of the torsion bar spring.
5. Remove torque arm.
Remove the two torque arm mounting nuts.
Torque: 49 Nm (36 ft. lbs.).
INSTALLATION
Installation is in the reverse order of removal. After installation, check the front wheel alignment.