T100 Regular Cab Pickup 2WD L4-2693cc 2.7L DOHC MFI (1998)
e. Install the shift lock release link.
Torque: 4.9 Nm (50 kgf-cm, 43 inch lbs.)
f.
Tighten the screw.
Torque: 1.4 Nm (14 kgf-cm, 12 inch lbs.)
g. Turn the ignition switch key plate in the ACC position.
h. Set the control shaft in the D position.
i.
Measure the clearance of the stopper and shift lock plate.
Clearance: 1.0 ± 0.8 mm (0.039 ± 0.031 inch)
When the control shaft is set in D position, check that the ignition key plate does not turn to LOCK position.
k. When the control lever is changed from the R position to L position, check that the shift lock plate does not interfere with stopper.
l.
Set the control shaft in the P position.
When the ignition key plate is turned from the LOCK position to the ACC position, check that the stopper is unlocked from the lock condition.
3. TORQUE SHIFT LEVER ASSEMBLY MOUNTING BOLTS
Torque: 29 Nm (300 kgf-cm, 22 ft. lbs.)
4. INSTALL SHIFT LEVER ASSEMBLY WITH STEERING COLUMN ASSEMBLY
5. CHECK AND ADJUST SHIFT LEVER POSITION