T100 Regular Cab Pickup 2WD V6-3.4L (5VZ-FE) (1997)
/Page-1656007.png)
a. To prevent oil seal lip damage, wind vinyl tape on the steering rack end, and apply power steering fluid.
b. Coat a new O-ring with power steering fluid and install it to the bushing.
c. Push in the bushing.
NOTICE: Make sure to install the bushing facing the correct direction.
d. Push in the cylinder end stopper until the wire installation hole appears.
5. Install wire, as follows:
a. Insert a new wire end into the hole of the rack housing.
b. Using Special Service Tool (SST) 09631 - 10021 or equivalent, turn the cylinder end stopper clockwise until the wire end disappears.
6. Air tightness test.
a. Install SST 09631 - 12071 or equivalent, to the rack housing.
b. Apply 53.3 kPa (15.75 inch Hg) of vacuum for about 30 seconds.
c. Check that there is no change in the vacuum. If there is change in the vacuum, check the installation of the oil seals.
7. Install control valve assembly, as follows:
a. Coat the Teflon rings with power steering fluid.
b. To prevent oil seal lip damage, wind vinyl tape on the serrated part of the valve shaft.
c. Install the valve assembly into the control valve housing
NOTICE: Be careful not to damage the teflon rings and oil seal.
8. Install oil seal, as follows:
a. Coat a new oil seal lip with power steering fluid.