T100 Regular Cab Pickup 4WD V6-3.4L (5VZ-FE) (1998)
Receiver Dryer: Service and Repair
REMOVAL
1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
HINT: At the time of installation, please refer to the following item.
Evacuate air from refrigeration system.
Charge system with refrigerant and inspect for leakage of refrigerant.
Specified amount: 650 ± 50 g (22.92 ± 1.76 oz.)
2. REMOVE RADIATOR GRILLE
3. DISCONNECT LIQUID TUBE BETWEEN RECEIVER AND COOLING UNIT
Remove the bolt and disconnect the liquid tube.
Torque: 5.4 N.m (55 kgf.cm, 48 in.lbf)
NOTE: Cap the open fillings immediately to keep moisture or dirt out of the system.
HINT: At the time of installation, please refer to the following item.
Lubricate 2 new O-ring with compressor oil and install the tube.
4. REMOVE RECEIVER FROM RECEIVER HOLDER
Remove the holder bolt and pull the receiver upward from the holder.
HINT: At the time of installation, please refer to the following item.
If receiver is replaced, add compressor oil to receiver.
Add 20 cc (0.71 ft.oz.)
Compressor oil: ND-OIL 8 or equivalent
INSTALLATION
Installation is in the reverse order of removal