T100 SR5 Extra Cab Pickup 2WD V6-3.4L (5VZ-FE) (1997)
/Page-1536004.png)
REASSEMBLY CAUTION: Be careful not to damage the rubber lips on the pistons.
(c) Place a rag and 2 wooden blocks on the work table and lightly tap the cylinder flange against the blocks until the No. 2 piston drops out of the
cylinder.
NOTE: Make sure the distance (A) from the rag to the top of the blocks is at least 100 mm (3.94 inch).
INSPECTION
NOTE: Clean the disassembled parts with compressed air.
1. Inspect cylinder bore for rust or scoring.
2. Inspect cylinder for wear or damage.
If necessary, clean or replace the cylinder.
REASSEMBLY
Reassembly is in the reverse order of disassembly.
CAUTION: Apply lithium soap base glycol grease to the rubber parts indicated by the arrows in EXPLODED VIEW of system.
INSTALLATION
Installation is in the reverse order of removal.
Before installation, adjust length of brake booster push rod.
After installation, fill brake reservoir with brake fluid, bleed brake system. See: Brake Bleeding/Service and Repair
Check for leaks, check and adjust brake pedal. See: Brake Pedal Assy/Adjustments
