toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Steering Gear|Removal and Installation|Page 5512 > < Steering Gear|Removal and Installation|Page 5510
Page 3
background image

Maximum runout: 0.30 (0.0118 inch).

b. Check the back surface for wear or damage.

2. If necessary, replace oil seal and bearing, as follows:

a. Using Special Service Tool (SST) 09950 - 60010 (09951 - 00250), 09950-70010 (09951 - 07150) or equivalents, tap out the oil seal and

bearing from the control valve housing.  

b. Coat a new oil seal lip with power steering fluid.

c. Using SST 09960 - 60010 (09951 - 00180, 09951 - 00320, 09952 - 06010), 09950 - 70010 (09951 - 07200) or equivalents, press in the oil

seal.   

NOTICE: Make sure to install the oil seal facing the correct direction.

d. Using SST 09950 - 60010 (09951 - 00180, 09951 - 00340, 09952 - 06010), 09950 - 70010 (09951 - 07200) or equivalents, press in a new

bearing.  

3. If necessary, replace two bearings.

a. Using a brass bar, drive out the bearing from the rack housing.

Steering Gear|Removal and Installation|Page 5512 > < Steering Gear|Removal and Installation|Page 5510