T100 SR5 Extra Cab Pickup 2WD V6-3.4L (5VZ-FE) (1997)
/Page-1400008.png)
9. Install straight pin and 1st gear thrust washer. Install the 1st gear thrust washer onto the output shaft with the straight pin aligned with the 1st gear
thrust washer.
10. Install output shaft center bearing, as follows:
Using SST 09316-60011 (09316-00011, 09316-00071) and a hammer, drive in the bearing with the outer race snap ring groove toward the rear.
11. Inspect 1st gear thrust clearance.
12. Inspect 2nd gear thrust clearance.
13. Install 5th gear. Using SST 09316-60011 (09316-00031) or equivalents, and a press, install the 5th gear.
