T100 SR5 Extra Cab Pickup 4WD V6-3.4L (5VZ-FE) (1998)
Alignment: Service and Repair
INSPECTION
1. MEASURE THE VEHICLE HEIGHT.
Vehicle Height: refer to Specifications / Mechanical.
Front: A-B
Rear: C-D
Measuring Points:
A: Drive shaft height measured at its center on the outer edge.
B: Lower suspension arm front adjusting bolt height measured at its center.
C: Rear leaf spring front bushing height measured at its center.
D: Rear axle shaft height measured at its center.
NOTICE:
-
Before inspecting the wheel alignment, adjust the vehicle height to specification.
-
If the vehicle height is not standard, try to adjust it by pushing down on or lifting the body.
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR ONTO THE WHEEL ALIGNMENT TESTER.
Follow the specific instructions of the equipment manufacturer.
3. INSPECT THE CAMBER, CASTER AND THE STEERING AXIS INCLINATION.
STD Cab: