Tacoma 2WD V6-3.4L (5VZ-FE) (1995)
this, these steps should be carried out.
A. Intake.
(a)
Apply new engine oil to the thrust portion and journal of the camshaft.
(b) Place the intake camshaft at 90° angle of timing mark (1 dot mark) on the cylinder head.
(c)
Apply MP grease to a new oil seal lip.
(d) Install the oil seal to the camshaft.
(e)
Remove any old packing FIPG material.
(f)
Apply seal packing to the No. 1 bearing cap as shown.
Seal packing: Part No. 08826 - 00080 or equivalent.
(g) Install the 5 bearing caps in their proper locations.
(h) Apply a light coat of engine oil on the threads and under the heads of the bearing cap bolts.