Tacoma 2WD V6-4.0L (1GR-FE) (2006)
d. for LH Side and Separate Seat Type RH Side:
1. Install the floor anchor of the front seat outer belt with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
NOTE:
-
Make sure that the floor anchor of the front seat outer belt is oriented in the correct direction when installing.
-
Be careful not to place the floor anchor of the front seat outer belt over the convex areas of the floor panel.
e. for Bench Seat Type RH Side:
1. Install the wiring harness clamp.
2. Connect the belt tension sensor connector.
3. Install the floor anchor of the front seat outer belt with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
HINT:
-
Make sure that the floor anchor of the front seat outer belt is oriented in the correct direction when installing.
-
Be careful not to place the floor anchor of the front seat outer belt over the convex areas of the floor panel.
10. INSTALL QUARTER INSIDE TRIM BOARD RH
HINT: Follow the same procedures as for the quarter inside trim board LH.