Tacoma 2WD V6-4.0L (1GR-FE) (2006)
4. Using SST, connect terminals TS and CG of the DLC3.
SST 09843-18040
5. Turn the ignition switch to the ON position.
6. Keep the vehicle stationary on a level surface for 2 seconds or more.
7. Check that the VSC TRAC warning light blinks as shown in the illustration.
NOTE: The VSC TRAC warning light (and VSC OFF indicator light (4WD, with rear differential lock)) stay ON when obtaining the zero
point.
HINT:
-
If the VSC warning light does not blink, perform the zero point calibration again.
-
The zero point calibration is performed only once after the system enters test mode.
-
Calibration cannot be performed again until the stored data is cleared once.