Tacoma 2WD V6-4.0L (1GR-FE) (2006)
/Page-391006.png)
7. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
a. Remove the 10 bolts, 3 seal washers, 2 nuts, cylinder head cover and gasket.
8. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY LH
a. Remove the 10 bolts, 3 seal washers, 2 nuts, cylinder head cover and gasket.
9. SET NO. 1 CYLINDER TO TDC/COMPRESSION
a. Turn the crankshaft pulley until its groove and the timing mark 0 of the timing chain cover are aligned.
b. Check that the timing marks of the camshaft timing gears are aligned with the timing marks of the bearing cap as shown in the illustration.
If not, turn the crankshaft 1 complete revolution (360°) and align the timing marks above.
