Tacoma 2WD V6-4.0L (1GR-FE) (2006)
Repair Procedure
1. Locate the point of contact at the wire harness cover to the HVAC bracket shown in Figure 1.
2. Remove the wire harness grommet (clip) from the HVAC bracket as shown in Figure 2.
NOTICE
Be careful NOT to damage the wire harness grommet (clip) when removing since this clip will be reused.
3. Apply EPT foam to the edge of the HVAC bracket at the point of contact and wrap it to the underside of the bracket as shown in Figure 3.
Width = 30 mm (1.20 in.)