Tacoma 2WD V6-4.0L (1GR-FE) (2006)
/Page-1569001.png)
Fuel Gauge: Testing and Inspection
Component Inspection
INSPECT FUEL RECEIVER GAUGE
a. Disconnect the fuel sender gauge connector.
b. Turn the ignition switch to the ON position, then check the position of the receiver gauge needle.
OK: Needle position is on (EMPTY).
c. Connect terminals 2 and 3 on the wire harness side connector of the fuel sender gauge.
d. Turn the ignition switch to the ON position, then check the position of the receiver gauge needle.
OK: Needle position is on (FULL).
e. Reconnect the fuel sender gauge connector.
