Tacoma 2WD V6-4.0L (1GR-FE) (2006)
Turn Signal Flasher: Testing and Inspection
TURN SIGNAL FLASHER ASSEMBLY
ON-VEHICLE INSPECTION
1. INSPECT TURN SIGNAL FLASHER ASSEMBLY (w/o Daytime Running Light System)
a. Check the power source circuit and ground circuit.
1. Remove the turn signal flasher assembly from the instrument panel junction block assembly.
2. Measure the voltage and check the results in accordance with the value(s) shown in the table.
3. Measure the resistance and check the result in accordance with the value(s) shown in the table.
b. Check the output operation signal.