Tacoma 2WD V6-4.0L (1GR-FE) (2006)
2. Press SST activation switch and check that the LED of SST activation switch turns on.
CAUTION: If the LED turns on when the activation switch is not being pressed, SST may be malfunctioning. Do not use SST.
b. Disconnect SST from the battery.
c. Disconnect the pretensioner connector.
1. Disconnect cable from negative battery terminal.
2. Remove the access panel rear weatherstrip.
3. Remove the lap belt outer anchor cover.
4. Remove the door pull handle.
5. Remove the access panel inside handle bezel.
6. Remove the rear door trim board.
7. Install the floor anchor with the bolt.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
8. Disconnect the pretensioner connector as shown in the illustration.
d. Connect the SST.