Tacoma 2WD V6-4.0L (1GR-FE) (2006)
/Page-1343002.png)
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
3. REMOVE REAR SEAT BACK HINGE COVER
4. REMOVE REAR SEAT BACK ASSEMBLY LH
5. REMOVE REAR SEAT BACK HINGE SUB-ASSEMBLY LH
6. REMOVE REAR DOOR SCUFF PLATE LH
7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
8. REMOVE LUGGAGE COMPARTMENT SIDE TRAY
9. REMOVE QUARTER TRIM LOWER PANEL LH
10. REMOVE QUARTER INSIDE TRIM BOARD LH
11. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH
12. REMOVE REAR AIRBAG SENSOR
a. Disconnect the connector from the rear airbag sensor.
b. Remove the nut and the rear airbag sensor.
INSTALLATION
HINT: Use the same procedures for the RH side and LH side.
1. INSTALL REAR AIRBAG SENSOR
a. Check that the ignition switch is OFF.
b. Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION: After disconnecting the cable from the terminal, wait for at least 90 seconds before starting the operation.
c. Install the rear airbag sensor with the nut.
Torque: 9.0 N.m (92 kgf.cm, 80 in.lbf)
NOTE:
-
Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed to the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, make sure that the SRS wiring does not interfere with any other parts and is not pinched between
other parts.
-
After installation, shake the sensor assembly to check that it is not loose.
2. INSTALL REAR SEAT OUTER BELT ASSEMBLY LH
3. INSTALL QUARTER INSIDE TRIM BOARD LH
4. INSTALL QUARTER TRIM LOWER PANEL LH
5. INSTALL LUGGAGE COMPARTMENT SIDE TRAY
6. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH
7. INSTALL REAR DOOR SCUFF PLATE LH
8. INSTALL REAR SEAT BACK HINGE SUB-ASSEMBLY LH
9. INSTALL REAR SEAT BACK ASSEMBLY LH
10. INSTALL REAR SEAT BACK HINGE COVER
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
12. INSPECT SRS WARNING LIGHT
