Tacoma 2WD V6-4.0L (1GR-FE) (2006)
Wheel Speed Sensor: Service and Repair
Rear Speed Sensor
REAR SPEED SENSOR
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE REAR SPEED SENSOR
a. Disconnect the speed sensor connector.
b. Remove the nut and speed sensor rear.
NOTE:
-
Do not attach any foreign matter to the sensor tip.
-
Ensure that no foreign matter enters the sensor installation hole.
INSTALLATION
1. INSTALL REAR SPEED SENSOR
a. Install the rear speed sensor with the nut.
Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
NOTE: Make sure that the sensor tip is clean.
b. Connect the speed sensor connector.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N.m (40 kgf.cm, 35 in.lbf)
3. CHECK VSC SENSOR SIGNAL (w/ VSC)
4. CHECK ABS SENSOR SIGNAL (w/o VSC)