Tacoma 2WD V6-4.0L (1GR-FE) (2006)
d. Install the end frame with the 2 screws.
Torque: 3.8 N.m (39 kgf.cm, 34 in.lbf)
3. INSTALL MAGNET STARTER SWITCH ASSEMBLY
a. Apply grease to the steel ball, and install it onto the clutch shaft hole.
b. Apply grease to parts (2) - (5), and install all the parts below onto the starter drive housing.
c. Install the magnet starter switch with the 2 screws.
Torque: 9.3 N.m (95 kgf.cm, 82 in.lbf)
4. INSTALL STARTER YOKE ASSEMBLY
a. Install a new O-ring onto the groove of the starter yoke.