Tacoma 2WD V6-4.0L (1GR-FE) (2006)
16.
Install the NEW clutch pedal sub-assembly.
A.
Install the clutch pedal onto the clutch support with the bolt and nut.
Torque: 34 N.m
(347 kgf.cm, 25 ft.lbf)
HINT
Install the bolt from the left side of the vehicle.
B.
Apply MP grease to the clutch pedal sub-assembly where the clevis sub-assembly contacts the clutch pedal.
NOTE:
Failure to apply grease to the clevis and clutch pedal sub-assemblies could cause the noise to return.
C.
Tighten the bolt to the instrument panel reinforcement assembly.
Torque: 8 N.m (82 kgf.cm, 6 ft.lbf)
17.
Install the turnover (compression) spring.
A.
Apply MP grease to the contact surface of the spring holder, clutch pedal, and spring.
B.
Install the spring onto the clutch pedal and spring holder.