Tacoma 2WD V6-4.0L (1GR-FE) (2006)
/Page-875001.png)
Pressure Plate: Specifications
Pressure Plate
CLUTCH COVER ASSEMBLY
Align the matchmarks on the clutch cover assembly and flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts, in the order starting with the bolt located near the knock pin on the top.
Torque ............................................................................................................................................................................ 19 Nm (195 kgf-cm, 14 ft. lbs.)
HINT: Following the order in the illustration, uniformly tighten the bolts.
Move SST up and down, right and left lightly, after checking that the disc is in the center, and tighten the bolts.
