Tacoma 4WD L4-164.4 2693cc 2.7L DOHC (3RZ-FE) (1996)
![background image](/toyota/tacoma_4wd/l4-164.4_2693cc_2.7l_dohc_(3rz-fe)/Page-1038001.png)
Engine RPM Sensor (NE signal): Service and Repair
REMOVAL
1. REMOVE ENGINE UNDER COVER.
2. REMOVE GENERATOR.
3. REMOVE GENERATOR BRACKET.
-
Remove the 3 bolts and bracket.
Torque:
Bolt A: 74.5 Nm (55 ft lb)
Bolt B: 18 Nm (13 ft lb)
4. DISCONNECT CRANKSHAFT POSITION SENSOR CONNECTOR.
5. REMOVE CRANKSHAFT POSITION SENSOR.
-
Remove the 2 bolts and crankshaft position sensor.
Torque: 8.5 Nm (74 in lb)
-
Remove the O-ring.
CRANK SHAFT POSITION SENSOR INSTALLATION
INSTALLATION HINT: Installation is in the reverse order of removal.