Toyota Workshop Service and Repair Manuals

Output Shaft: Specifications

Gear Thrust Clearance

1st, 2nd and 3rd Gears

Standard ........................................................................................................................................................  0.10-0.25 mm (0.0039-0.0098 inch)
Maximum ...........................................................................................................................................................................  0.30 mm (0.0118 inch)

Gear Radial Clearance

1st, 2nd and 5th Gears

Standard ....................................................................................................................................................  0.009-0.060 mm (0.0004-0.0024 inch)
Maximum .........................................................................................................................................................................  0.150 mm (0.0059 inch)

3rd Gear

Standard ....................................................................................................................................................  0.015-0.066 mm (0.0006-0.0026 inch)
Maximum .........................................................................................................................................................................  0.200 mm (0.0079 inch)

First Gear Inner Race

Outer Diameter, Minimum ...................................................................................................................................................  42.975 mm (1.6919 inch)
Flange Thickness, Minimum ....................................................................................................................................................  4.78 mm (0.1881 inch)

Output Shaft Flange Thickness

Minimum .................................................................................................................................................................................  5.60 mm (0.2205 inch)

Outer Diameter Of The Output Shaft Journal, Minimum Diameter

2nd Gear ..............................................................................................................................................................................  42.975 mm (1.6919 inch)
3rd Gear ...............................................................................................................................................................................  31.969 mm (1.2586 inch)

Shaft Runout

Maximum .................................................................................................................................................................................  0.06 mm (0.0024 inch)