Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
After replacing the cruise control ECU, perform the cable adjustment procedure as necessary.
1.
Confirm cable free play:
A. Eliminate slack of inner cable by pushing the inner cable toward the actuator until it stops. While the cable is held, mark the position of the
cable by using tape.
B. Pull the inner cable toward the throttle cam and measure the clearance between the mark and the outer cable tip.
2.
Adjust the cable free play:
A. Loosen lock nut of throttle cam side and adjust the clearance to 1 or 2 mm.
B. Tighten lock nut of actuator side.
Torque: 12 N-m/8 ft-lbs
C. Confirm clearance of 1 to 2 mm.