Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
7. INSTALL CONTROL VALVE ASSEMBLY
a. Coat the teflon rings with power steering fluid.
b. To prevent oil seal lip damage, wind vinyl tape on the serrated part of the control valve shaft.
c. Push the valve assembly into the control valve housing.
NOTICE: Be careful not to damage the teflon rings and oil seal lip.
8. INSTALL OIL SEAL
a. Coat a new oil seal lip with power steering fluid.
b. Using SST, press in the oil seal.
SST 09612-22011
NOTICE: Make sure to install the oil seal facing the correct direction.
9. INSTALL CONTROL VALVE HOUSING WITH CONTROL VALVE ASSEMBLY
a. Place a new gasket on the rack housing.
b. Align the matchmarks on the valve housing and rack housing.
c. Torque the 2 bolts.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
10. INSTALL SELF-LOCKING NUT
Using SST to stop the control valve shaft rotating, torque a new nut.
SST 09616-00010
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)
11. INSTALL DUST COVER