Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
d. Using SST turn the control valve shaft right and left 1 or 2 times.
SST 09616-00010
e. Using SST loosen the cap until the rack guide spring is not functioning.
SST 09631-10021
f.
Using SST and a torque wrench, tighten the cap until the preload is within specification.
SST 09616-00010, 09631-10021
Preload (turning): 0.9 - 1.5 Nm (9 - 15 kgf-cm, 7.8 - 13.0 inch lbs.)
15. INSTALL RACK GUIDE SPRING CAP LOCK NUT
a. Apply sealant to 2 or 3 threads of the nut.
Sealant: Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
b. Using SST to hold the rack guide spring cap, and using SST, torque the nut.
SST 09631-10021, 09922-10010
Torque: 50 Nm (513 kgf-cm, 37 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Recheck the total preload.
Preload (turning): 0.9 - 1.5 Nm (9 - 15 kgf-cm, 7.8 - 13.0 inch lbs.)
d. Remove the RH and LH rack ends.
16. INSTALL RACK HOUSING NO.2 BRACKET AND GROMMET
a. Align the matchmarks on the bracket and rack housing.
b. Torque the bolt.
Torque: 61 Nm (620 kgf-cm, 45 ft. lbs.)