Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
Parking Pawl: Service and Repair
ON-VEHICLE REPAIR
1. REMOVE DRAIN PLUG AND DRAIN ATF
2. REMOVE VALVE BODY. Refer to Valve Body; Service and Repair.
3. REMOVE PARKING LOCK PAWL BRACKET
Remove the 2 bolts, wave washers and parking lock pawl bracket.
4. REMOVE PARKING LOCK PAWL
a. Remove the spring from parking lock pawl pivot pin.
b. Remove the pivot pin and parking lock pawl.
c. Remove the E-ring from the pivot pin.
5. INSTALL PARKING LOCK PAWL
a. Install the E-ring to the pivot pin.
b. Install the parking lock pawl, pivot pin and spring.
6. INSTALL PARKING LOCK PAWL BRACKET
Install the bracket and tighten the 2 bolts with the wave washers.
Torque: 7.4 Nm (75 kgf cm, 65 inch lbs.)
HINT: Push the parking lock rod fully forward.
7. CHECK PARKING LOCK PAWL OPERATION