Tacoma Extra Cab 2WD L4-2.4L (2RZ-FE) (1999)
Seals and Gaskets: Service and Repair
ON-VEHICLE REPAIR
1. REMOVE PROPELLER SHAFT. Refer to Drive/Propeller Shaft; Service and Repair.
2. REMOVE REAR OIL SEAL
Using SST, remove the oil seal.
SST 09308-10010
NOTICE: Clean the extension housing before removing the oil seal.
3. INSTALL NEW OIL SEAL
Coat the lip of a new oil seal with MP grease and using SST and a hammer, carefully drive the oil seal in as far as it will go.
SST 09325-20010
4. INSTALL PROPELLER SHAFT
5. CHECK FLUID LEVEL.