Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
Brake Caliper: Service and Repair
Removal and Installation
REMOVAL
1. Disconnect flexible hose.
a. Remove the union bolt and disconnect the flexible hose.
Torque: 30 Nm (22 ft. lbs.)
NOTICE: At the time of installation, for correct brake hose routing, ensure that the hose hangs down before installing hose to caliper.
b. Use a container to catch the brake fluid.
2. Remove caliper from torque plate.
Remove the 2 slide pins and caliper.
Torque: 88 Nm (65 ft. lbs.)
3. Remove these parts:
-
2 brake pads with anti-squeal shims and pad wear indicator.
-
4 pads support plates.
INSTALLATION
Installation is in the reverse order of removal. After installation, fill brake reservoir with brake fluid, bleed brake system and check for leaks.