Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
4. INSPECT STATOR FOR OPEN CIRCUIT
Using an ohmmeter, check that there is continuity between the coil leads.
If there is no continuity, replace the drive end frame assembly.
5. INSPECT STATOR FOR GROUND
Using an ohmmeter, check that there is no continuity between the coil leads and drive end frame.
If there is continuity, replace the drive end frame assembly.
6. INSPECT EXPOSED BRUSH LENGTH
Using a scale, measure the exposed brush length.
Standard exposed length:
9.5 - 11.5 mm (0.374 - 0.452 in.)
Minimum exposed length:
1.5 mm (0.059 in.)
If the exposed length is less than the minimum, replace the brushes.
7. IF NECESSARY, REPLACE BRUSHES