Tacoma Extra Cab 2WD V6-3.4L (5VZ-FE) (1998)
/Page-1473008.png)
15. REMOVE CYLINDER END STOPPER.
a. Using SST 09631 - 10021, turn the stopper clockwise until the wire end is visible through the service hole.
b. Using SST 09631-10021, turn the stopper counterclockwise, and remove the wire.
16. REMOVE STEERING RACK AND OIL SEAL.
a. Using an extension bar and socket wrench (19 mm), press out the rack with the bushing.
NOTICE: Take care not to drop the rack.
b. Remove the bushing from the rack.
c. Remove the O-ring from the bushing.
17. REMOVE OIL SEAL.
Using SST 09950-60010 (09951 -00280), 09950-70010 (09951-07360), press out the oil seal.
INSPECTION
NOTICE: When using a vise, do not overtighten it.
1. INSPECT STEERING RACK.
a. Using a dial indicator, check the rack for runout and for teeth wear and damage.
Maximum runout: 0.3 mm (0.0118 inch)
b. Check the back surface for wear and damage.
