Tacoma Extra Cab 4WD L4-2.7L (3RZ-FE) (1999)
Brake Caliper: Service and Repair
Removal and Installation
NOTICE:
-
RZN191L: Tacoma Prerunner Reg Cab 2WD 2.7L (3RZ-FE)
-
RZN196L: Tacoma Prerunner Extra Cab 2WD 2.7L DOHC (3RZ-FE)
-
VZN195L: Tacoma Prerunner Extra Cab 2WD 3.4L DOHC (5VZ-FE)
HINT: Pre runner is the described below.
RZN191L-TRPDKAB, RZN196L-CRPDKAB, VZN195L-CRPDKAB
REMOVAL
1. REMOVE FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
2. DISCONNECT FLEXIBLE HOSE
Remove the union bolt and 2 gaskets from the caliper, then disconnect the flexible hose from the caliper.
Torque: 30 Nm (310 kgf-cm, 22 ft. lbs.)
HINT: At the time of installation, install the flexible hose lock securely in the lock hole in the caliper.
3. REMOVE CALIPER
Remove the 2 mounting bolts and caliper.
Torque: 123 Nm (1,250 kgf-cm, 90 ft. lbs.)
4. REMOVE CLIP, 2 PINS AND ANTI-RATTLE SPRING
5. REMOVE 2 PADS WITH 4 ANTI-SQUEAL SHIMS
INSTALLATION
Installation Is in the reverse order of removal.
HINT: After installation, fill the brake reservoir with brake fluid, bleed brake system and check for leaks.