Tacoma Extra Cab 4WD V6-3.4L (5VZ-FE) (1998)
/Page-1547017.png)
f.
Using SST 09610-00010 and a torque wrench, tighten the cap until the preload is within specification.
Preload (turning): 0.5-1.7 Nm (4.1 -14.9 in. lbs.)
12. INSTALL RACK GUIDE SPRING CAP LOCK NUT.
a. Apply sealant to 2 or 3 threads of the nut.
Sealant: THREE BOND 1344, LOCTITE 242 or equivalent
b. Holding the rack guide spring cap rotating, and using SST 09922-10010, torque the nut.
Torque: 51 Nm (38 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Recheck the total preload.
Preload (turning): 0.5-1.7 Nm (4.1 -14.9 in. lbs.)
d. Remove the RH and LH rack ends.
13. INSTALL RH AND LH CLAW WASHERS AND RACK ENDS.
a. Install a new washer, and temporarily tighten the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST 09922-10010, torque the rack end.
Torque: 76 Nm (56 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).