Tacoma Extra Cab 4WD V6-3.4L (5VZ-FE) (1998)
/Page-1153002.png)
1. PULL OUT BOOT WITH PUSH ROD
2. REMOVE PISTON
Using compressed air, remove the piston with the spring from the cylinder.
Reassembly
1. COAT PISTON WITH LITHIUM SOAP BASE GLYCOL GREASE, AS SHOWN
2. INSTALL PISTON WITH SPRING INTO CYLINDER
3. INSTALL BOOT WITH PUSH ROD TO CYLINDER
Installation
Installation is in the reverse order of removal.
HINT: After installation, bleed clutch system.