Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
Crankshaft Position Sensor: Service and Repair
REPLACEMENT
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY NO.1 (PRE RUNNER AND 4WD TYPE)
3. REMOVE FAN AND GENERATOR BELT (W/ AIR CONDITIONING)
4. REMOVE COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONING)
5. REMOVE IDLE PULLEY ASSEMBLY W/BRACKET (W/ AIR CONDITIONING)
a. Remove the 5 bolts, then remove the idle pulley with bracket.
6. REMOVE CRANKSHAFT POSITION SENSOR
a. Disconnect the crankshaft position sensor connector and the 2 wire harness clamps.
b. Remove the bolt, then remove the crankshaft position sensor.
7. INSTALL CRANKSHAFT POSITION SENSOR