Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
12. INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
a. Check the amount of inclination required to lock the retractor.
1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any
directions. Also check that the belt locks when the inclination of the retractor is 45° or more.
NOTE: Do not disassemble the retractor.
If operation is not as specified, replace the front seat outer belt.
b. Hook the lower stay of the retractor onto the 2 body hooks.
c. Tighten bolt A, and then tighten bolt B.
Torque:
8.5 N.m (85 kgf.cm, 75 in.lbf) for bolt A
42 N.m (430 kgf.cm, 31 ft.lbf) for bolt B
d. Connect the pretensioner connector as shown in the illustration.
e. Install the shoulder anchor with the nut.
Torque: 42 N.m (430 kgf.cm, 31 ft.lbf)
f.
Check that the shoulder anchor rotates smoothly.