Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
Wheel Speed Sensor: Service and Repair
Front
SPEED SENSOR FRONT LH
REPLACEMENT
HINT: The replacement procedures for the RH side are the same as those for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE FRONT WHEEL
3. REMOVE SPEED SENSOR FRONT LH
a. Disconnect the speed sensor connector.
b. Remove the bolt and front speed sensor.
NOTICE:
-
Do not attach any foreign matter to the sensor tip.
-
Ensure that no foreign matter enters the sensor installation part.
4. INSTALL SPEED SENSOR FRONT LH
a. Install the front speed sensor with the bolt.
Torque: 8.3 Nm (85 kgf-cm, 73 inch lbs.)
NOTICE: Make sure that the sensor tip is clean.
b. Connect the speed sensor connector.
5. INSTALL FRONT WHEEL
Torque: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 Nm (40 kgf-cm, 35 inch lbs.)
7. CHECK ABS SENSOR SIGNAL