Tacoma PreRunner L4-2.7L (2TR-FE) (2005)
B.
Remove the clevis sub-assembly from the master cylinder.
a.
Loosen the lock nut.
b.
Rotate and remove the clevis sub-assembly.
15.
Install the NEW clevis sub-assembly.
A.
Rotate the lock nut to match length "A".
B.
Rotate and install the NEW clevis sub-assembly to contact the lock nut.
C.
Tighten the lock nut and torque to specification.
Torque: 11.8 N.m (120 kgf.cm, 8.7 ft.lbf)
D.
Apply MP grease to the ball end of the clevis sub-assembly where it will contact the clutch pedal.