Tacoma PreRunner 2WD V6-3.4L (5VZ-FE) (2003)
![background image](/toyota/tacoma_prerunner_2wd/v6-3.4l_(5vz-fe)/Page-334001.png)
Ignition Cable: Testing and Inspection
INSPECT HIGH-TENSION CORDS
a. Remove the air cleaner hose.
b. Disconnect the high-tension cords at the rubber boot.
Do not pull on the high-tension cords.
NOTE: Pulling on or bending the cords may damage the conductor inside.
c. Using an ohmmeter, measure the high-tension cord resistance.
Maximum resistance: 25 kOhm per cord
If the resistance is greater than maximum, check the terminals.
If necessary, replace the high-tension cord.