Tacoma PreRunner 2WD V6-3.4L (5VZ-FE) (2003)
/Page-746002.png)
Part 2 Of 2
DISASSEMBLY
1. 4WD: REMOVE OIL SEAL (INSIDE)
a. Clamp the axle hub in a soft jaw vise.
HINT: Close vise until it holds hub bolts. Do not tighten further.
b. Using a screwdriver, remove the oil seal (inside).
2. Pre runner: REMOVE GREASE CAP
a. Clamp the axle hub in a soft jaw vise.
HINT: Close vise until it holds hub bolts. Do not tighten further.
b. Using a screwdriver, remove the grease cap.
3. Pre runner: REMOVE LOCK NUT AND ABS SPEED SENSOR ROTOR/SPACER