toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Body - Water Leaks to The Interior|Page 4757 > < Body - Water Leaks to The Interior|Page 4755
Page 3
background image

6.

Mask-off wiper motor opening.

7.

Attach Kent(TM) 12" extension tube (P/N 90175) to the nozzle on the can of Leak-Chek(TM) (P/N 50087).

NOTE:

Direct Leak-Chek(TM) spray material approximately 1 inch above seam. Spray force is very strong - make several test passes before actually
spraying material into seam.

8.

Spray Leak-Chek(TM) through the wiper motor opening.

a.

Spray material inside upper cowl, beginning in lower corner, and continuing toward the centerline of vehicle.

b.

Remove wand from the wiper motor opening and insert it into larger cowl openings on the right hand side. Continue spraying material along
entire seam until seam is filled from R/F fender to L/F fender area.

Spray Leak-Chek(TM) into seam a total of 3 times, allowing Leak-Chek(TM) to flash dry for 30-45 minutes between applications. (Drying time
increases as outside temperature decreases.)

9.

After final application of Leak-Chek(TM) has been allowed to dry for approximately one hour, flood area with water for 5-10 minutes.

NOTE:

Hold garden hose at top right front corner of windshield and point hose downward toward lower right hand corner of windshield as shown.

10.

Check inside cab behind Heater/Air Conditioner box for evidence of water leakage during water leak check.

11.

Carefully inspect "T" joint on right and left sides (close to heater motor box, and brake booster) for evidence of water leaks.

12.

If no leaks are found, cowl area leak repair is complete. Reinstall wiper motor, cowl trim panel, wiper arms, and hood.

Wiper Arm Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)

If water leaks are still present and are coming in from the cowl area, remove right front fender and proceed as follows:

13.

Seal around entire perimeter of "L" bracket with Kent High Tech(TM) Clear Seam Sealer (see drawing for location of "L" bracket).

14.

Using a flashlight, look through the 2" x 3" rectangular hole on side of vertical cowl panel and locate vertical seam that connects side of cowl to
front cowl.

Body - Water Leaks to The Interior|Page 4757 > < Body - Water Leaks to The Interior|Page 4755