Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
3. BLEED BRAKE LINE
(a) Connect the vinyl tube to the caliper or wheel cylinder bleeder plug.
HINT: Begin air bleeding from the wheel cylinder with the longest hydraulic.
(b) Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down.
(c) At the point when fluid stops coming out, tighten the bleeder plug, then release the brake pedal.
(d) Repeat (b) and (c) until all the air in the fluid has been bled out.
Torque: (Bleeder plug) 11 Nm (110 kgf-cm, 8 ft. lbs.)
(e) Repeat the procedure on the previous page to bleed the air out of brake line for each wheel.
4. CHECK FLUID LEVEL IN RESERVOIR
Check the fluid level and add fluid if necessary.
Fluid: SAE J1703 or FMVSS No. 116 DOT3
LOAD SENSING PROPORTIONING AND BY-PASS VALVE ON-VEHICLE INSPECTION
HINT: Pre runner is the described.
RZN191L-TRPDKAB, RZN196L-CRPDKAB, RZN196L-PRPDKAB, VZN195L-CRPDKAB, VZN195L-PRPDKAB
1. SET REAR AXLE LOAD
Rear axle load (includes vehicle weight):
2. INSTALL LSP & BV GAUGE (SST) AND BLEED AIR
SST 09709-29018