Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
(a) Install the load sensing valve boot and load sensing spring boot.
(b) Install the 2 rubber plates, 2 collars and 4 bushings.
HINT:
-
Apply lithium soap-base glycol grease to all rubbing areas.
-
Do not mistake the valve side for the shackle side of the load sensing spring.
2. INSTALL SHACKLE NO. 1 AND NO. 2
(a) Install the lock nut washer and shackle No. 1 to the shackle No. 2.
(b) Torque the nut.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
3. INSTALL LOAD SENSING SPRING TO SHACKLE NO.1
(a) Install the load sensing spring and 2 plate washers to the shackle No. 1.
(b) Install the bolt and nut.
Torque: 18 Nm (185 kgf-cm, 13 ft. lbs.)
4. INSTALL LOAD SENSING SPRING TO VALVE BODY
Install the load sensing spring to the load sensing valve with the clip.
5. INSTALL VALVE BRACKET
(a) 2WD (except pre runner):
Install the set plate to the valve assembly through the valve bracket and temporarily tighten the 2 valve body mounting nuts with flexible hose
bracket.
(b) 4WD and pre runner:
Install the set plate to the valve assembly through the valve bracket and temporarily tighten the 2 valve body mounting nuts.
(c) Install the bolt and nut with the 2 plate washers.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)