Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
Wheel Speed Sensor: Service and Repair
Speed Sensor, Front
REMOVAL
HINT: Pre runner is the described.
RZN191L-TRPDKAB, RZN196L-CRPDKAB, RZN196L-PRPDKAB, VZN195L-CRPDKAB, VZN195L-CRPDKAB,
REMOVE SPEED SENSOR
(a) Disconnect the speed sensor connector.
(b) Remove the 2 (4WD and pre runner) or 4 (2WD (except pre runner)) clamp bolts holding the sensor harness from the steering knuckle, upper arm
and side rail.
Torque:
Upper arm, steering knuckle: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
Side rail: 13 Nm (130 kgf-cm, 9 ft. lbs.)
(c) Remove the speed sensor installation bolt from the steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
NOTICE: At the time of installation, please refer to the following items.
-
There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be installed.
-
The sensor is installed flat against the knuckle when you tighten the bolt.
-
When installing the resin clips, use new ones.
INSTALLATION
Installation is in the reverse order of removal.