Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
Drive Belt: Service and Repair
REMOVAL
1. REMOVE PS PUMP DRIVE BELT
2. REMOVE ENGINE UNDER COVER
3. LOOSEN IDLE PULLEY LOCK NUT
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
4. REMOVE COMPRESSOR DRIVE BELT
Loosen drive belt tension by adjusting bolt and remove the drive belt.
INSTALLATION
1. TIGHTEN IDLE PULLEY LOCK NUT TEMPORALLY
Torque: 2.5 N.m (25 kgf.cm, 22 in.lbf)
2. INSTALL DRIVE BELT
3. USING ADJUSTING BOLT, ADJUST DRIVE BELT TENSION
Drive belt tension
New belt: 160 ± 25 lbf
Used belt: 100 ± 25 lbf
4. TIGHTEN IDLE PULLEY LOCK NUT
Torque: 39 N.m (400 kgf.cm, 29 ft.lbf)
5. INSTALL PS PUMP DRIVE BELT
6. INSTALL ENGINE UNDER COVER