Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
13. INSTALL CRANKSHAFT PULLEY
a. Align the pulley set key with the key groove of the pulley, and slide the pulley.
b. Using SST, install a new bolt.
SST 09213-54015 (90119-08216), 09330-00021
Torque: 295 Nm (3,000 kgf-cm, 217 ft. lbs.)
14. INSTALL FAN BRACKET
a. Install the fan bracket with the bolt and nut.
b. Install the PS pump adjusting strut with the nut.
15. INSTALL NO.2 TIMING BELT COVER
a. Check that the timing belt cover gasket has no cracks or peeling, etc.
If the gasket does have cracks or peeling, etc., replace it using these steps.
1. Using a screwdriver and gasket scraper, remove all the old gasket material.
2. Thoroughly clean all components to remove all the loose material.
3. Remove the backing paper from a new gasket and install the gasket evenly to the part of the belt cover shaded black.
b. Install the timing belt cover with the 6 bolts.
Torque: 9 Nm (90 kgf-cm, 80 inch lbs.)
c. Connect the 4 high-tension cord clamps and camshaft position sensor connector to the timing belt cover.
16. INSTALL OIL DIPSTICK AND GUIDE
a. Install a new O-ring to the dipstick guide.
b. Apply soapy water to the O-ring.
c. Install the oil dipstick and guide to the cylinder block.
d. Install the bolt to the generator bracket.
Torque: 8 Nm (80 kgf-cm, 71 inch lbs.)
17. INSTALL A/C COMPRESSOR BRACKET
Torque: 47 Nm (479 kgf-cm, 35 ft. lbs.)
18. TEMPORARILY INSTALL FAN WITH FLUID COUPLING AND FAN PULLEYS
19. INSTALL NO.2 FAN SHROUD
20. INSTALL AND ADJUST DRIVE BELT FOR GENERATOR
21. TIGHTEN FAN WITH FLUID COUPLING AND FAN PULLEY
Torque: 5.4 Nm (54 kgf-cm, 48 inch lbs.)
22. CONNECT A/C COMPRESSOR TO ENGINE
a. Install the A/C compressor with the 4 bolts.
Torque: 25 Nm (250 kgf-cm, 18 ft. lbs.)