Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
/Page-1013001.png)
Blower Motor Resistor: Testing and Inspection
BLOWER RESISTOR
INSPECTION
1. REMOVE GLOVE COMPARTMENT PARTS
2. REMOVE BLOWER RESISTOR
a. Disconnect the resister connector from the blower resistor.
b. Remove the 2 screws and blower resistor.
3. INSPECT BLOWER RESISTOR RESISTANCE
If resistance is not as specified, replace the blower resistor.
4. INSTALL BLOWER RESISTOR
a. Install the blower resistor with the 2 screws.
b. Connect the resister connector to the blower resistor.
5. INSTALL GLOVE COMPARTMENT PARTS
