Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
Compressor And Magnetic Clutch
REMOVAL
1. RUN ENGINE AT IDLE SPEED WITH A/C ON FOR APPROX. 10 MINUTES WITH A/C ON
2. STOP ENGINE
3. DISCONNECT NEGATIVE (-) TERMINAL CABLE FROM BATTERY
4. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
5. REMOVE ENGINE UNDER COVER
6. DISCONNECT DISCHARGE AND SUCTION HOSES
Remove the 2 bolts and disconnect the both hoses.
NOTE: Cap the open fitting immediately to keep moisture or dirt out of the system.
7. REMOVE DRIVE BELT
8. 5VZ-FE Engine Models:
REMOVE PS PUMP SET BOLT AND NUT
9. REMOVE COMPRESSOR
a. Disconnect the connector.
b. Remove the 4 bolts and compressor.
INSTALLATION
1. INSTALL COMPRESSOR
a. Install the compressor with 4 bolts.
Torque: 25 N.m (250 kgf.cm, 18 ft.lbf)
b. Connect the connector.